Invisibrake Activates on Jeep When Started But Not Connected to Motorhome
Updated 12/09/2020 | Published 12/07/2020
Question:
I recently installed the instibrake on my 2020 jeep and everything worked fine until a week later while not hooked up to the motorhome the instibrake activated. What could of made the brakes activate when the jeep was started?
asked by: Ronald M
Expert Reply:
I discussed your issue with both my in-house installers and technical support at Roadmaster and they both came up with the same concerns. It is likely moisture and/or corrosion at the multi-pin connector at the front of your Jeep.
I have attached a picture of a typical connector and would like you to note that it has a plate that attaches with 2 screws and a rubber boot behind it. If you take off the screws and pull it out, then pull the boot back you will expose the area where the individual pins are connected. In there you must eradicate any moisture or corrosion you find. If any moisture causes a short between pins you could have the problem described.
It would be worthwhile to inspect the connections at your tail lights as well. Since it has been working correctly for a while it is unlikely to be that your inline diodes are backwards and allowing any back feeding into the system.
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Flat Tow Brake System
- Brake Systems
- Pre-Set System
- One-Time Setup
- Vehicle Battery
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Indicator Lights
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Vehicle Tow Bar Brake System
- Shop: Vehicle Tow Bar Wiring
- Shop: Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Q&A: How Does the Roadmaster Guardian Rock Guard Install on the Road Master EZ4 Base Plate Kit
- Video: Step-By-Step Installation Tutorial for the RoadMaster Stop Light Switch Kit on a 2014 Jeep Wrangler
- Q&A: Do all of the Wires of the Invisi-Brake Need to Be Wired to Install Brake Kit
- Q&A: Where to Install Diodes when Installing Roadmaster Invisibrake with Tow Bar Lighting
- Shop: Plastic Oil Draining Pan with Pouring Spout - 4-Gallon Capacity
- Q&A: Brake Light Switch Wire Color to Install a Brake Controller on a 2015 Jeep Wrangler Unlimited
- Search Results: stop light switch flat tow brake system
- Search Results: vehicle tow bar brake system
- Video: All About the Hopkins Custom Tail Light Wiring Kit for Towed Vehicles
- Shop: Roadmaster Stop Light Switch Kit
- Video: Blue Ox Replacement Breakaway Switch Installation - 2015 Jeep Wrangler Unlimited
- Video: The Low-Down on the Roadmaster Stop Light Switch Kit
- Video: All About the Roadmaster Stop Light Switch Kit
- Video: Install: Roadmaster InvisiBrake Flat Tow Brake System on a 2016 Jeep Wrangler Unlimited
- Search Results: invisabrake
- Shop: Replacement Audio Alarm Circuit Board for Roadmaster InvisiBrake Flat Tow Brake System
- Shop: Second Motorhome Braking Monitor/Alarm Kit for Roadmaster InvisiBrake Systems
- Shop: Replacement Monitor Wire for Roadmaster LED Braking Indicator - RV-Side - 50' Long
- Shop: Roadmaster Universal Stop Light Switch Kit
- Video: In-Depth Review of the Roadmaster Universal Stop Light Switch Kit
- Search Results: trailer hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Search Results: trailer wiring
- Shop: Trailer Wiring
on Flat Tow Brake System
