Replacement TruXedo Shur-Bond Velcro for 6-1/2 Foot Bed 1 Inch Wide

Question

Question:

Replacement Velcro for truxedo tonneau cover roll up 1” wide 6.5 long?

asked by: Will E

0

Expert Reply:

The Replacement TruXedo Shur-Bond Hook-And-Loop Fastener Strips # TX1117876 is what you are seeking. It is 1 inch wide and 80 inches long.

expert reply by: Jason S

0

Answer 1

No, the Replacement TruXedo TruXport Shur-Bond Hook-And-Loop Fastener Strips #TX1117876 is not the correct replacement Velcro for your TruXedo Lo Pro Soft Roll-up Tonneau Cover #TX570601. Instead, you would want to use the Replacement TruXedo…

view full answer...

Answer 2

It sounds like you're talking about the Velcro strips that keep the cover secure on the sides on your 2010 Nissan Frontier. You can use the Replacement TruXedo TruXport Shur-Bond Hook-And-Loop Fastener Strips for 6-1/2' Beds #TX1117876 and…

view full answer...

Answer 3

For replacement Velcro for the Truxedo X15 tonneau you have installed on your 2013 Ram 2500 short bed you'd want the part #TX1117876.

view full answer...

Answer 4

I have a solution for you, and the strips that you're referring to are going to come in a couple different sizes, but none of them are going to be 1-1/16" wide. The #TX1117876 strips you're referring to are 1" wide, which have the…

view full answer...

Answer 5

The Replacement TruXedo Shur-Bond Hook-And-Loop Fastener for your TruXsport cover on your Toyota Tundra is 80 inches long and 1 inch wide. It is part #TX1117876.

view full answer...

Answer 6

Replacement Truxedo Shur-Bond Velcro Brand Fastener #TX1117876 is the same 1 inch width and it is the hook portion only just like #A60270 which is the Access replacement part. So it will fit its just that the 2 parts, the Tonneau cover and strip,…

view full answer...

Answer 7

Hi Craig; according to TruXedo, the Replacement TruXedo TruXport Shur-Bond Hook-And-Loop Fastener Strips #TX1117876 are 1" wide. There are a lot of products I'm able to measure out in our warehouse but, this one ships directly from the…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Replacement TruXedo Shur-Bond Velcro for 6-1/2 Foot Bed 1 Inch Wide

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching