Where is the "Momentary" Button on the LINC Remote?

Updated 05/05/2025 | Published 11/21/2020

Question:

What is the monetary button Linc Analog Remote

asked by: Dwight

Expert Reply:

We get this question a lot. The momentary push button on your Lippert LINC system that you need to press to program the Remote Control # LC292614 is not on the remote, but rather on the LINC receiver box which is usually located near the generator. After you press and hold this button on the receiver you will press the light bulb button on the remote until you hear a relay in the receiver click, then release that button on the receiver. The two should now be synced.

I have atttached further programming instructions.

expert reply by: Les D

click to enlarge

Dustin N.

8/4/2024

Show me a picture of where the MOMENTARY PUSH BUTTON is located on any camper. I don't care. I do not have a generator. I do not have a dashboard or ignition switch. I have a trailer. 2013 Salem Cruise light. Where is the receiver box? Where is the controller box? Where is the MOMENTARY PUSH BUTTON? Where could it be physically on my trailer? I need to press this thing to get my stabilizers up after a lightning strike. Please tell me the location... show me a picture. I need to know where it is specifically on the camper. Where I should look? What does it look like?

Jesse M.

8/5/2024

@DustinN Hey Dustin, we do not have any build sheets or anything that will tell us the location of the push button on a specific camper. The best way to find this out will be to get ahold of a Salem RV dealership. They will be the only ones with access to that kind of info.

Dustin N.

8/5/2024

@JesseM thank you. It appears that way. If and when I figure out where it is I will post a picture and detailed information on the location for my model. I was able to manually retract my stabilizers after disconnecting from the battery. A lightning strike took out several components and we're tracking them all down. We replaced the main power cable, then the inverter, then the air conditioning, power board and digital thermostat. The switches for the awning and the stabilizers do not work. The remote control WILL still control the awning and the front stabilizers. It's puzzling. I'm guessing the switches all are fried and the rear stabilizer motor is also fried. Thanks for the help. I hope this helps anybody else in this kind of situation.

Vince R.

5/3/2025

@DustinN hey Dustin, I just found this forum on e-trailer. This is 9 months late but.. LOL. I have a 2015 Forest River Salem Cruise light. The receiver box is behind the control panel underneath the refrigerator in mine. There is four screws to remove and slide out the control panel and inverter to see/get to the receiver box and there is a button on the front. It's just a black button. Not labeled.