Can the T-Handle Door Latch Assemblies # L4080 Be Ordered Keyed-Alike?

Question

Question:

If I buy 4 of these locks can i have them keyd alike

asked by: Allan

0

Expert Reply:

According to my Redline representative, all of the # L4080 T-Handle locks are keyed alike.

I have confirmed this myself by pulling a few of them off the shelf in the warehouse. They all use the same key number, so if you order four of them, they will all be keyed alike.

expert reply by: Mike L

0

Tex

4/4/2024

Not much for security, anyone who has same mechanism has access .

Mike L.

4/10/2024

@Tex True, but this isn't very widely known.

Answer 1

The crank handle for the Lippert Components Spare Tire Winch with Offset Cable item #LC159056, is Replacement Crank Extension for Lippert Spare Tire Winch Assemblies - 35-1/2" item #LC1315411. The Spare Tire Winch item #LC159056 has a 1/2-inch…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Marcus, congrats on the new truck! Since your Silverado 3500 has the B&W Turnoverball item #BWGNRK1016, I recommend the B&W Companion item #BWRVK3500. This hitch has a 20,000 lbs capacity and will connect directly to the square gooseneck…

view full answer...

Answer 9

The AT15775 part that you referenced was a replacement latch repair kit from Atwood for yoke style A-frame couplers. This kit is no longer available as Atwood was bought out and their parts were discontinued. For a replacement yoke style coupler for…

view full answer...

Answer 10

It sure will Terry and congrats on the new SUV! The Curt Hitch item #C58GJ does indeed fit the new 2026 Audi Q5 Sportback. The Curt item #C58GJ is a custom fit class III hitch with a 2" receiver, a 5,000 lbs towing capacity, and a maximum tongue…

view full answer...

Answer 11

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

Answer 12

I believe the CH751 is the lock number. There are various lock numbers that could be in a door handle. The number you provided is a patent number for a double lock T-handle. Such as #L4080 which is the closest match we have to that design.

view full answer...

Can the T-Handle Door Latch Assemblies # L4080 Be Ordered Keyed-Alike?

Product Page this Question was Asked From

Continue Researching