Recommended Weight Distribution Hitch for 10,000-lbs GVWR Dump Trailer
Updated 11/07/2020 | Published 11/05/2020
Products Featured in This Question
Question:
I just got a dump trailer. 10k GVWR. Id like to use a weight distribution hitch but the location of the box for hydraulics is in the way for where you would typically mount brackets for the bars. Are there other options that might work for this configuration?
asked by: Chad
Helpful Expert Reply:
I recommend using the Curt MV Weight Distribution System w/ Friction Sway Control - Round Bar - 14K GTW, 1.4K TW # C17063, which will work well for your 10000-lbs GVWR trailer; you will want to make sure that your trailer does not exceed the 1400-lbs tongue weight capacity of this system. In order to use this system on your trailer frame you'll need to install the Chain Hangers for Curt Weight Distribution Systems - Bolt On # C17005, which will allow you to work around the hydraulic box that you mentioned. The MV is a good economical system that will help reduce the strain on your tow vehicle's rear suspension, and the integrated sway control will help improve your overall towing experience and safety.
I've linked a review video of this system for you to check out.
Product Page this Question was Asked From
Curt Round Bar Weight Distribution System w/ Friction Sway Control - 14K GTW, 1.4K TW
- Weight Distribution Hitch
- WD With Sway Control
- Round Bar
- Fits 3 Inch Frame
- Fits 4 Inch Frame
- Fits 5 Inch Frame
- Fits 6 Inch Frame
- Includes Shank
- 2-5/16 Inch Ball
- Fits 2 Inch Hitch
- Requires Disconnection
- 1100 lbs
- 1200 lbs
- 1300 lbs
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Is Weight Distribution Needed for 2019 Chevy Silverado 1500 Towing 2019 Keystone Hideout 22RBWE
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Q&A: Troubleshooting Surt Chain Hangers Not Having Room to Fit on Trailer Tongue
- Q&A: What Would Cause Trailer to Sway Using Andersen Weight Distribution System
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Best Weight Distribution System For A 2014 V-Cross Vibe Limited Series M-6504
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Replacement Hub and Drum Assembly for Lippert 4,400 lb Axle
- Q&A: How to Lift 2025 Keystone Coleman 17B
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)