How Tall Is the Americana Trailer Wheel Center Cap 5.12" Cap

Question

Question:

How tall is the 5.12 center cap?

asked by: Tyson

0

Expert Reply:

The Americana Trailer Wheel Center Cap part # AM90083 is 4-3/4" tall.

expert reply by: Conner L

0

click to enlarge

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 3

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 4

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

view full answer...

Answer 5

The MORryde Quick Connect RV Steps #MR25HR weigh 50 pounds.

view full answer...

Answer 6

Hi Susan, That part number comes up as a 60lb gas strut with a 20" extended length and 10mm socket so the Taylor Made Marine Gas Strut for Boat Hatches #3691843-60 would be a fit. To remove your current strut you'll need to stick a small…

view full answer...

Answer 7

Hi Scott! You are absolutely correct. The same standard bolt would be used on both sides of the leaf spring, even when it is a slipper spring. The only exception to that would be if it was a wet bolt, as that would just leak grease everywhere and…

view full answer...

Answer 8

I spoke with my contact at Lippert regarding the existing Lippert 1716 Pin Box #LC1324791 on your trailer. He stated that you can actually replace the pin box with the Lippert 1116 Pin Box #LC1270271, which is shorter than what you have but uses the…

view full answer...

Answer 9

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Answer 10

Blane, what you're looking for is the 7-Leaf Double-Eye Spring for 8,000-lb Trailer Axles #DX74XR. This spring has a 4k capacity, will work with 8k axles, has 1 3/4" wide leaves. You'll notice that these springs are a bit shorter, but…

view full answer...

How Tall Is the Americana Trailer Wheel Center Cap 5.12" Cap

Product Page this Question was Asked From

Continue Researching