Puck Light Replacement for RV Ceiling that is 3-3/4 inches Diameter

Question

Question:

I am looking for puck lights that are 3.75inch on the front and 2.75inch on the back. There are 2 wires on the back and there are two clamps that hold it to the roof.

asked by: Mike

0

Expert Reply:

In the spring mount style of puck light the closest option we have is the part # DG52445VP that you referenced but would require you to slightly open up the holes in your ceiling if what you have is 2-3/4 inches in diameter as this needs a 3 inch hole.

expert reply by: Jameson C

0

click to enlarge

Answer 1

For a front hitch for your 2023 Ford F-350 dually I recommend the Draw-Tite #65076. This is going to be the only front hitch we offer that will fit the DRW models. This has a 2" receiver and a 500 lb vertical load limit. As far as installation,…

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 8

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

view full answer...

Answer 9

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 10

Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…

view full answer...

Answer 11

I wasn't able to find any model information on your Sunlink RSBF3NN-008 and we don't carry that particular brand, but we do have a number of recessed puck lights available that may work for you. You may be able to use the Gustafson RV Puck…

view full answer...

Puck Light Replacement for RV Ceiling that is 3-3/4 inches Diameter

Product Page this Question was Asked From

Continue Researching