Correct Curt 5th Wheel Brackets and Rails for a 2013 Toyota Tundra 6.5' Bed

Question

Question:

Hi will these fit my 2013 Tundra 6.5 ft bed?

asked by: Patrick L

0

Expert Reply:

The correct Curt Custom Fifth Wheel Installation Kit for a 2013 Toyota Tundra 6.5' Bed (No Crew Max) is part # C16468-204 which is composed of the brackets part # C16468 and rails part # C16204.

expert reply by: Conner L

0

Answer 1

Hey Mike! We've got a couple of different options for 5th wheel brackets that fit your 2007 Toyota Tundra. You're going to want to match up the brand of your rails with the corresponding brackets. I have listed options for Curt and Reese…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Hey Connor, since your 2007 Toyota Tundra comes with a factory 7-way the correct kit to install the Redarc Tow Pro Liberty would be the part #RED82CR which comes with the correct harness that plugs in under the dash of your truck. What are you…

view full answer...

Answer 8

Sure, I can help with that. I can see why the fitment notes are confusing. For a 2012 Toyota Tundra with the factory tow package and factory 7 way connector, you'll want a brake controller that plugs into the factory brake controller port under…

view full answer...

Answer 9

Hey Dale, thanks for reaching out. For your 2010 Toyota Tundra with the factory tow package, a proportional controller is definitely the way to go for smooth braking on a 2-axle trailer, and a really clean option is the Redarc Tow-Pro Liberty…

view full answer...

Answer 10

Hey Zigman, the Redarc Tow Pro Liberty part #RED98CR that you referenced is the best option for a brake controller for your 2026 Toyota Tundra SR. This is one of the best performing brake controllers out there and it only puts a small knob on the…

view full answer...

Correct Curt 5th Wheel Brackets and Rails for a 2013 Toyota Tundra 6.5' Bed

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching