Does Rhino Rack Roof rack for Factory Tracks Fit Tracks on SnugTop Camper Shell

Question

Question:

I have a SnugTop shell on the back of my truck that already has factory installed rails. Can you tell me if the Y02-490B-NT Rhino will fit the SnugTop? Will I require any adapters? Thanks.

asked by: Frank

0

Expert Reply:

The Rhino-Rack Roof Rack for Factory Tracks # Y02-490B-NT that you referenced is a direct fit for the factory tracks you have on top of your SnugTop camper shell. This comes with everything you'd need too so you wouldn't need any additional parts.

expert reply by: Jameson C

0

Answer 1

Hello Ralph, thanks for reaching out. The etrailer Electric Trailer Jack #e23ZV will be a great option for you. The jack can be rotated to the side if needed. We have one of these jacks on our trailer here at the shop and I have seen it rotated and…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 4

Hey, I totally get why you’re pausing here. The last thing you want is to buy the wrong parts, start drilling into that Leer cap, and end up with something that doesn’t seal or fit right. From what you’re describing, those metal pieces at the four…

view full answer...

Answer 5

Hey Steve, so the tracks on the top of your camper shell were designed to fit several roof rack brands but the best option overall and for the money is the Rhino Rack roof rack for camper shell tracks part #Y02-490B-NT as this gives you a higher…

view full answer...

Answer 6

Hey Jesse! The feet/legs and crossbars need to match so you wouldn't use Thule feet with another set of crossbars. However, the tracks are pretty universal so other roof rack brands will be able to fit. As far as I know Thule still doesn't…

view full answer...

Answer 7

Hey Richard, congrats on the new topper and truck! The 46" Long Rhino-Rack Vortex Roof Rack for Tracks item #RR62XE are most likely going to be too short for your Tacoma's topper but the Rhino-Rack Roof Rack for Factory Tracks item…

view full answer...

Answer 8

Yes, the Thule UpRide #TH599000 will fit the T-Slot channels of the Rhino-Rack Vortex crossbars. The Rhino-Rack tracks don't have extra end caps available but I do have another solution for you. I confirmed this with my contact at Rhino-Rack. The…

view full answer...

Answer 9

I do have some replacement options but we don't carry Barker jacks so I wouldn't be able to assist with wiring a new switch as I know nothing about them. That said, I did look in the manual and found a schematic which is attached below but…

view full answer...

Answer 10

The GearDeck 17 Enclosed Cargo Carrier #H00604 does have a fair number of parts to put together. That said, it would not be considered difficult to assemble in my opinion because you're really only working with some bolts, screws, washers and…

view full answer...

Answer 11

I'd be happy to help you with a rack system above the Pace Edwards UltraGroove Retractable Hard Tonneau Cover #PE57CV for the long bed on your 2023 GMC Sierra 3500. For a simple rack system you can use the Rhino-Rack Vortex Crossbars…

view full answer...

Does Rhino Rack Roof rack for Factory Tracks Fit Tracks on SnugTop Camper Shell

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching