How To Use Middle Legs on Lippert Ground Control 3.0 Without Controller
Updated 06/16/2020 | Published 06/12/2020 >
Question:
In March I purchased a Lippert Ground Control 3.0 6 point set. Because I am using this system on a Box Truck and not a fifth wheel, I have to make some modifications. One such modification is using the middle jack to support the landing gear because of the weight of the cab. The controller will not let me operate the middle jacks even in the manual mode. So, my question is what is the schematic of the jacks so I can make my own controller for just those two jacks? Thank You,
asked by: John G
Expert Reply:
The reason you're having this issue is because the middle jacks on the Lippert Ground Control 3.0 (6 point set) # LC675817 aren't designed to be run independently and will only come down after auto-leveling has been completed.
There is not a wiring schematic available for these jacks, but if you're looking to run them independently of the Ground Control remote system you will need to locate the power and ground wire (the larger wires connected to the motor) and setup a switch system on your own. There are two other wires that are connected to the middle legs that are for the hull effect to be used when leveling, so they're not going to be used in your application.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Fluid Filters
- Shop: Curt RockerBall Anti-Rattle Towing Kit - 2" Ball - 8-1/4" Long Mount - 7,500 lbs
- Shop: Shocker Hitch XRC Cushioned Ball Mount - 2" Ball - 2-1/2" Hitch - 7-1/2" Drop - 10K
- Shop: LubriMatic Multi-Purpose Lithium Grease - 3 oz. Cartridges - 3 Pack
- Shop: PTC Custom Fit Engine Oil Filter - Conventional and Synthetic
- Shop: PTC Custom Fit Engine Oil Filter - Conventional and Synthetic
- Shop: PTC Custom Fit Engine Oil Filter - Conventional and Synthetic
- Shop: PTC Custom Fit Engine Oil Filter - Conventional and Synthetic
- Q&A: Wrench Needed To Remove Trailer Wheel Lug Nuts and Most Common Lug Nut Sizes on Trailer Wheels
- Q&A: Troubleshooting Right Rear Jack Not Retracting on Lippert Ground Control jacks
- Q&A: Middle Jack Isn't Working on a Lippert 3.0 LC675817
- Q&A: Troubleshooting Lippert Power Jack that Will Not Lift or Lower
- Q&A: Trailer Hitch Ball Wrench Size and Torque Rating for 1-1/4 Inch Hitch Ball Shank Size
- Q&A: Does Electric Ground Control TT Level Trailer on Uneven Ground
- Q&A: Will Electric Ground Control TT Leveling System Work Without Tongue Jack
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer tires and wheels
- Shop: Trailer Wiring
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement
- Search Results: trailer wiring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Brake Controller
- Video: Redarc Tow-Pro Liberty Brake Controller Review RED24FR
- Search Results: trailer jack
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040

