Which Is the Correct Lift Kit for a 2014 Lance Travel Trailer Model 2285

Question

Question:

Is the: Torflex Lift Kit - Tandem Axle - 2-7/8inch Lift Item # K71-724-02, the CORRECT LIFT KITinch for my 2014 Lance Travel Trailer Model 2285? Please let me know so I can order the kit. Thank you,

asked by: Terry M

0

Expert Reply:

The 2014 Lance Travel Trailer Model 2285 uses Dexter Torflex Torsion Axles therefore we should have a lift kit for this trailer. That said, you will need to provide the axle capacity or axle model number in order for us to confirm fit. The Torflex Lift Kit part # K71-724-02 is for model #11 axles with 4,100 lb -6,000 lb capacity. I have attached a full list of option below.

expert reply by: Conner L

0

Answer 1

Hey Matt, welcome back! For your 235/85 R16 tires, you'll need the Counteract Tire Balancing Beads for Tandem Axle Trailers item #CA83VR. This is a 4-pack of balancing beads that are designed specifically for 235/85 R16 trailer tires. This kit…

view full answer...

Answer 2

Though we have not yet installed the Torflex Lift Kit on a 2014 Lance Lance 1985 Travel Trailer, if you have 3,500 lb Torflex Axles I can confirm that the Torflex Lift Kit part #K71-707-02 will work for you so long as you do not have 3" tall…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 11

Not another one! Just kidding Dirk! I was in the Marines I enjoy these conversion questions on the M1101 trailers. I'd be more than happy to list the parts you need, along with quantity, and confirm compatibility. 1 - Timbren Axle-Less Trailer…

view full answer...

Which Is the Correct Lift Kit for a 2014 Lance Travel Trailer Model 2285

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching