Replacement Tarp for Extang eMax Tonneau Cover that Fits 2018 Chevy Silverado 1500 6.5 ft Bed

Question

Question:

Can you buy replacement cover for emax on a 2018 Chevy Silverado 6.6 bed

asked by: Dale

1

Helpful Expert Reply:

Yes, the correct replacement tarp you'd need is the # EX53FR for the eMax tonneau EX72450 that fits your 2018 Chevy Silverado 1500.

expert reply by: Jameson C

1

Answer 1

The Replacement Tarp #EX92405-20 is for a Extang Trifecta 2.0 Soft Tonneau Cover #EX92405 that fits a 2009 - 2014 Ford F-150 5-1/2 Foot Bed. To properly identify the correct replacement cover you will need to locate the part number on the tonneau.…

view full answer...

Answer 2

Hi Randy; the correct replacement tarp for your old 72475 is the Replacement Tarp for Extang eMAX Soft Tonneau Cover #EX29VJ.

view full answer...

Answer 3

The correct replacement tarp for your Extang EMax Tonneau Cover EX72445 can be found with part #EX44VR.

view full answer...

Answer 4

Hi Ronald; I'm sorry to say that a replacement tarp is not available for your eMAX. I just confirmed this with Extang. The tarp you were looking at would have been correct since the 72450 is the cover you have now. However, these ship directly…

view full answer...

Answer 5

There are a couple things that you can do that will help with the sway and bounce on your trailer when you are pulling it with your vehicle. The first thing you can try to do is tow the trailer level. If the tongue on the trailer is high, then the…

view full answer...

Answer 6

I am happy to determine the replacement cover for you but I would need the serial number off of your older Extang cover. The easiest way is to locate the serial number. Most of the time the serial number can be found on the driver's side front…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Hello Joe, Thanks for writing in! Based on the measurements you provided, the Gen-Y Glyder Shock Absorbing Ball Mount #325-GH-12001 is not the right fit for your setup. Since your Tundra's receiver measures 18 inches from the ground and your TAB…

view full answer...

Replacement Tarp for Extang eMax Tonneau Cover that Fits 2018 Chevy Silverado 1500 6.5 ft Bed

Continue Researching