What Size Pipe Mount Does the Bulldog Square Jack w/ Round Pipe Mount BD182524 Use

Published 04/02/2020

Products Featured in This Question

Bulldog Replacement Pipe Mount for Swivel Jacks - 2-7/8" Female - Weld On - 7/8" Pull Pin

(5)

$36.21

Question:

I am looking at ordering this jack for a baler. My existing jack failed. I have a few questions on dimensions. My existing tube measures approximately 3inch diameter and the pin hole measures approximately 3/4, does that match this jack? Also, could you please send me the measurement from center of mount tube to bottom of foot with jack fully retracted and fully extended? Thank you for your help.

asked by: Pat

Expert Reply:

The Bulldog Square Jack w/ Round Pipe Mount part # BD182524 is designed to be used with the Bulldog Weld-On Jack Pipe Mount part # BD005122 which is 4" diameter with a 7/8" pin hole. I don't know of any jacks off-hand which match your pipe mount so you are going to be much better off just having a new pipe mount welded on.

The distance from the center of the mount to the bottom of the footplate is 17" while retracted and 29.6" while extended.

expert reply by: Conner L