Where to Connect Red and Blue Wires of TK22113 on 2017 Dodge Durango
Updated 04/14/2020 | Published 03/29/2020
Question:
Where do they connect exactly each of them 2017 Dodge Durango gt 12 gauge and 18 gauge blue wires
asked by: Jim
0
Expert Reply:
According to the install instructions for the Tekonsha 7-way part # TK22113 that fits your 2017 Dodge Durango the blue wire gets routed through the grommet in the floor on the driver side into the rear cargo area and then routed behind side cargo trim panels and above head liner where you'll locate a white wire with a yellow stripe which it connects to.
I also attached a couple pictures that show where you'll find the connection point as well.
expert reply by:
Jameson C
0
click to enlarge
click to enlarge
Continue Researching
- Search Results: 90195
- Shop: Trailer Wiring
- Shop: Suspension Enhancement
- Shop: Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle
- Shop: Brake Controller
- Q&A: Trouble Locating Green Wire For 12 Gauge Blue Wire To Connect With
- Q&A: OEM Replacement Wiring Harness Installation Assistance and Photos for 2016 Dodge Durango
- Q&A: Recommended 7-Way Trailer Wiring Harness for 2018 Dodge Durango Without Factory Tow Package
James
4/12/2020
So I had a u haul installer install the Tekonsha tk22113 oem wiring harnesses with the primus iq brake controller and when I plug my 7 way round trailer plug into the vehicle which is a 2017 Dodge Durango gt the lights signals and hazards all work with no issues but when I manually push brake controller it reads n.c . So I drove around a little bit and noticed twice that the gas cap door was open so for the fun of while driving I pushed the gas cap door button and the brakes locked up. Any chance I could get some help? I’m asssuming they tapped into the wrong wires