Does Using Curt Auxiliary LED Indicator Lights # C53201 Require Load Resistors
Updated 03/09/2020 | Published 03/08/2020
Question:
Since these are LED, do i need to install Load Resistor to prevent hyper flash?
asked by: Julius
0
Expert Reply:
This is a really good question since normally if you change vehicle taillights over to LED you have to use load resistors, but since the Curt Auxiliary LED Indicator Lights # C53201 that you referenced connect to the vehicle through trailer wiring the load resistors aren't needed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Auxiliary LED Indicator Lights
- Accessories and Parts
- Hitch Bike Racks
- Hitch Cargo Carrier
- Lights
- CURT
more information >
Continue Researching
- Shop: Curt Auxiliary LED Indicator Lights
- Shop: Hot-Line LED Third Brake Trailer Light Bar w/ Reflector - Stop, Turn, Tail - Submersible - Red Lens
- Q&A: How To Install The Curt Auxiliary LED Indicator Lights C53201 With Load Resistors DI34ZR
- Video: Curt Auxiliary LED Indicator Lights Review
- Search Results: tail light bar
- Q&A: Does etrailer Trailer Hitch Receiver for 2018 Dodge Journey Include Fishwire
- Q&A: Lighting Solution for Kuat NV 2.0 Bike Rack
- Q&A: How to Remove The Oris Detachable Hitch Receiver
- Q&A: Hitch And Wiring For A 2025 Volvo XC90
- Q&A: Recommended Flat Towing Parts for a 2022 Ford Maverick
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Roof Rack For 2022 Ford Escape With Factory Flush Rails
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Hitch Installation Tips
- Article: Trailer Wiring Diagrams
- Article: Rust Prevention
- Article: Must-Have Flat Towing Components
- Article: What Is a Supplemental Braking System?