Which Trailer Suspension Hanger Kit Do I Need For 27 Long x 2 Wide Slipper Spring On 6000-lb Axle

Question

Question:

What spring hanger or kit will I need with this spring?

asked by: Portia S

0

Expert Reply:

To mount your 27" long slipper springs # e67SR you'll need to choose between a kit for single axle trailers or a tandem axle trailer. If you have a single axle trailer you'll want to use the Single-Axle Trailer Hanger Kit for 2" Slipper Springs - 3-3/4" Tall Front # APS6SE. If you have a tandem axle trailer you'll want to use the Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 12" Long Equalizers # APT6SE.

Since these kits do not come with the mounting bolts to secure the springs to the axles, you may also need the U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles - 7" Long U-Bolts # APUBR-8. This kit is for a mounting your springs to a single axle, so for a tandem axle trailer you would need 2 kits.

expert reply by: Erik B

0

Answer 1

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 2

Hey Corry, you would basically want to mock up the Terran Industries Tandem-Axle Hanger Kit #TX85VJ with the 26-5/8 inch springs that you have and have the springs temporarily mounted in the hanger and the equalizers to get the correct dimensions to…

view full answer...

Answer 3

Hey Ryan. We only have one hub that'll fit a straight spindle with 1-3/8" item #L68149 inner and outer bearings. It's the Dexter 9-3/4" Hub-and-Rotor Assembly item #DX82UR. This zinc coated hub and rotor assembly has a 5 on…

view full answer...

Answer 4

Hey Gary! The note you're referencing applies when the Correct Track system is installed, which your setup does not have. The MORryde X-Factor Crossmember #MR33WR does include longer wet bolts to account for the added bracket thickness at the…

view full answer...

Answer 5

I did a little research and found that slipper spring #e74SR does have similar specs and measurements as Dexter spring 072-032-00. Both are 2 inches wide, 5-leaf slipper springs but #e74SR is 26-5/8 inches long with 3,500 pound capacity for 7,000…

view full answer...

Answer 6

In regards to the Curt Trailer Hitch Receiver part #C14048, the distance from the center of the front mounting hole to the center of the rear mounting hole is 17-1/4". The distance from the center of the mounting holes left to right is 31".…

view full answer...

Answer 7

Hi Leslie! The Replacement Bellows for Dometic Boat Vacuum Pump and Discharge Pump #DOM58FR is a part we get directly from Dometic and is not an off brand thing. This is made by Dometic for their Sealand J or S Series vacuum pump or T Series…

view full answer...

Which Trailer Suspension Hanger Kit Do I Need For 27 Long x 2 Wide Slipper Spring On 6000-lb Axle

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching