Are Propane Tanks Still Accessible with Stromberg Carlson Trailer Tray Cargo Carrier Installed

Question

Question:

I have a Coleman 2155BH. If I mount my generator on this, will I have to remove it to replace a propane tank?

asked by: Dave A

1

Helpful Expert Reply:

There's quite a bit of available room under the bunk adapter # CC-255 to allow you access to the propane tanks. I attached a couple pictures that shows how much room you'd have.

I also attached a review video link for more info on it as well!

expert reply by: Jameson C

1

click to enlarge

Answer 1

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

view full answer...

Answer 2

I was able to find a photo of a Lance travel trailer with the large 3 tank cover that you referenced. If your setup looks like the one in the photo, from what I can tell, you should be able to install the Stromberg Carlson Trailer Tray #CC-255, but…

view full answer...

Answer 3

You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…

view full answer...

Answer 4

You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…

view full answer...

Answer 5

The best way to power the interior lights in your trailer is with its own independent battery. You will not want to use the breakaway battery. The breakaway battery is only designed to operate the breakaway and will drain extremely quickly,…

view full answer...

Answer 6

If you check out the picture I attached you can see that when the Stromberg Carlson Bunk Adapter part #CC-255 is installed you still have really great access to the propane tanks of the RV.

view full answer...

Answer 7

I don't think you'd have any issue removing your propane covers with the #CC-255 installed. If you check out the pictures I attached you'll see this installed on a trailer that has the white version of your cover installed. In the last…

view full answer...

Answer 8

The Superwinch S5500 Trailer Winch #SW1455200 mounting bolt holes are separated apart by 3-3/4" on center (see attached photo). Attached is a review video for you to reference as well.

view full answer...

Answer 9

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

view full answer...

Answer 10

The center pin on the 7 way connector can be used for many different purposes, although it is typically used to carry the signal from the reverse lights on the vehicle to the trailer. If the trailer does not have reverse lights or a reverse lockout…

view full answer...

Answer 11

If those circuit breakers are indeed for the jack and the trailer brakes then they are likely redundant since the 12 volt circuit and brake circuit are already circuit protected on the vehicle side. Electric trailer jacks also usually have an…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Are Propane Tanks Still Accessible with Stromberg Carlson Trailer Tray Cargo Carrier Installed

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching