What is the Diameter of the Top of the Optronics Drop In Cup Holder?
Updated 11/30/2019 | Published 11/28/2019 >
Question:
What is the top diameter including the lip of the #302B? As best as I can determine the actual with of the hole in my holder is 3-1/6 inches wide. So I figure I would need a diameter of 3-3/8 across the top. Unfortunately, your dimensions and video do not address this issue. Please advise. Thank you for your assistance.
asked by: Alan F
Helpful Expert Reply:
The top diameter, including the lip, of the Optronics Drop In Cup Holder # 302B is 3-1/4" across, which is going to be slightly larger than the 3-1/6" opening on your 2020 Subaru Legacy, so this cup holder will work for you.
Product Page this Question was Asked From
Optronics Drop In Cup Holder - Single Tier - 2-3/4" Tall x 2-7/8" Diameter
- Cup Holder
- Cup Holder
- Drop-In
- Plastic
- Drain Holes
- 2-3/4T x 2-7/8W Inch
- Black
- Optronics
more information >
Continue Researching
- Shop: Optronics Drop In Cup Holder - Single Tier - 2-3/4" Tall x 2-7/8" Diameter
- Video: Let’s Check Out the Optronics Drop In Cup Holder
- Video: Feature Breakdown: Optronics Drop In Cup Holder
- Q&A: How To Determine Fit of the Optronics Drop In Cup Holder
- Q&A: What Replacement Cup Holder Do You Recommend that Does Not Narrow at the Bottom?
- Q&A: What Is The Cup Holder Width of the Optronics Foldable Cup Holder
- Q&A: Tow-Rax Cup Holder # TWSP2CH Dimensions
- Search Results: trailer hitch
- Video: Yakima WindShield Fairing for Roof Racks Spec Review
- Shop: Trailer Hitch
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Trailer Wiring
- Search Results: trailer jack
- Shop: Brake Controller
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Search Results: trailer lights
- Search Results: hitch
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Vehicle Tow Bar Wiring
- Search Results: roof rack
- Shop: Roof Rack
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: tow bar base plate
- Shop: Tire Chains
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: wind fairing
- Shop: Vehicle Lights
- Q&A: Replacement Rubber Plug For Ultra-Fab Trailer Jack UF38-944014
- Q&A: Looking for Replacement Slide Out Bulb Seal for 2015 Primetime Sanibel 5th wheel 36FT


