How To Determine Fit of the Optronics Drop In Cup Holder
Published 12/17/2019
Question:
Will this fit in a 2009 Chevy Astro van?
asked by: Sue
1
Helpful Expert Reply:
The Optronics Drop In Cup Holder part # 302B is not a vehicle specific component so I would not be able to confirm compatibility. That said, most cup holders are a standard size so you should not have any fitment issues. If you want to confirm then make sure the inner diameter of your existing cup holders measures at least 2-7/8" diameter.
expert reply by:
Conner L
1
Product Page this Question was Asked From
Optronics Drop In Cup Holder - Single Tier - 2-3/4" Tall x 2-7/8" Diameter
- Cup Holder
- Cup Holder
- Drop-In
- Plastic
- Drain Holes
- 2-3/4T x 2-7/8W Inch
- Black
- Optronics
more information >
Continue Researching
- Shop: Optronics Drop In Cup Holder - Single Tier - 2-3/4" Tall x 2-7/8" Diameter
- Video: Let’s Check Out the Optronics Drop In Cup Holder
- Q&A: What is the Diameter of the Top of the Optronics Drop In Cup Holder?
- Q&A: Will the Draw-Tite Hitch # DT78MR for 2019 Jeep Wrangler JL Unlimited Increase my Tongue Weight?
- Article: Trailer Tire Sizing
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring a Tow Vehicle to Tow a Dinghy
- Q&A: How to Read the Lippert Components Axle Description Measurements
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Recommended Replacement For A Dometic 630515.331 AC Rooftop Unit
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed To Connect A Smoke Hollow 205 Grill To On Board Regulated Propane
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Does Adding a Weight Distribution System Increase a Hitch's Gross Tongue Weight Capacity
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure