Is There a Completely Hidden Hitch Available for the 2020 Dodge Durango?

Question

Question:

I'm looking for a hitch that doesn't stick out too much for my 2020 Dodge Durango so that we can tow a small utility trailer. Is there one available?

asked by: Al

0

Expert Reply:

I have a great solution for you to mount a hitch behind the bumper on your 2020 Dodge Durango; have a look at the Draw-Tite Class III Max Frame # DT38MR. This hitch mounts behind the bumper and is accessible via the removable panel on the rear bumper so that it stays hidden when it's not in use.

When it comes to wiring, you'll want to use the Tekonsha # 118617 which plugs in behind the driver and passenger side tail lights to provide you with a 4 way connector on the rear of your vehicle. If your vehicle was equipped with the tow package wiring, you can instead use the Curt # C55515, which plugs into the US car connector at the rear of your vehicle and will also provide you with a 4 way trailer connection.

expert reply by: Erik B

0

click to enlarge

Answer 1

The most hidden trailer hitch available for your 2020 Dodge Durango is without a doubt the Draw-Tite Max-Frame Trailer Hitch Receiver #DT38MR. The 2" receiver for this Class III hitch will actually extend out through the bottom of the rear…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 5

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 6

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

No, it will not Bryan. The Redarc Tow-Pro Link item #RED57AR requires a USCAR port that comes with factory tow packages. The Stealth Hitches Hidden Trailer Hitch Receiver w/ Towing Kit item #SH25VR, that fits your 2023 BMW X5, does not have this…

view full answer...

Is There a Completely Hidden Hitch Available for the 2020 Dodge Durango?

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching