Replacement Round Nut For Older Roadmaster Falcon 2 Tow Bar

Question

Question:

can i get 2 replacement collar nuts also called round nuts for my old 2005 falcon 2 hitch?

asked by: Ray W

0

Expert Reply:

The replacement round nuts for the older Roadmaster Falcon 2 Tow Bar is part # RM650004-80 according to the tow bar's installation instructions.

expert reply by: Heather A

0

Answer 1

Thanks for reaching out Kenneth. The Replacement Shank for Roadmaster Nighthawk and Sterling Tow Bar #910019-40 is the correct replacement stinger for the Nighthawk tow bar but is not the same as the updated kit that Roadmaster is sending out related…

view full answer...

Answer 2

Hey Manuel! I'm sorry to say there are no rebuild kits available for the shank on your Falcon All-Terrain tow bar. The only option is to replace it with the Replacement Hitch Shank for Roadmaster BlackHawk 2 All-Terrain and Falcon All-Terrain Tow…

view full answer...

Answer 3

We do have some repair/replacement parts for your Roadmaster Falcon All Terrain Tow Bar #RM-522 including the following: Repair Kit - #RM910003-85 Nylatron Bushing - #RM-200029-70 Inner Arm - #910021-65 Round Nut - #RM650004-80 Attached is a picture…

view full answer...

Answer 4

Hello Tom. It sounds like you are looking for replacement parts for your Roadmaster Falcon 2 Tow bar Part #RM-520. You did not mention what exactly you are looking for, so here is a list of all of the replacement parts we carry for this tow bar: -…

view full answer...

Answer 5

I believe I have just the parts for you! For your 2019 Honda Fit, I recommend the Roadmaster Direct-Connect Base Plate Kit #RM-521571-5 for your base plate. This base plate is great because the drawbars are so easy to operate. Simply, insert them…

view full answer...

Answer 6

We do have everything you will need to flat tow your 2019 Honda Fit DX with the Manual transmission behind your Leisure travel van and carry your bikes. First you will need a Roadmaster Direct-Connect Base Plate Kit #RM-521571-5 for your Fit. You…

view full answer...

Answer 7

Hey Ezekiel, thanks for reaching out! Great questions about the Tow Ready #118158 and Curt #C56196 converters. When you put your hazards on, all bulbs connected to that output side of the converter for the turn signals will flash. As for the LED…

view full answer...

Answer 8

I spoke to my contact at Curt about the Vehicle to Vehicle Tail Light Converter part #C56196. They informed me that only one side (right side stop/tail or left side stop/tail) of the two wire system needs to be attached to the converter box in order…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Replacement Round Nut For Older Roadmaster Falcon 2 Tow Bar

Product Page this Question was Asked From

Continue Researching