Recommended Cover for 7x14 V-Nose Motorcycle Trailer

Question

Question:

Can you recommend a cover for my 7X14 v-nose low profile motorcycle trailer? It is approximately 16 feet long including the tongue, by 8.5 feet wide including the fenders, by 8 feet tall/high. Thank you very much for your time and your help. Sincerely,

asked by: Michael D

0

Expert Reply:

When choosing a trailer cover you actually disregard the tongue as part of the length and you only measure the box section of the trailer. Since your motorcycle trailer is 7x14 I recommend using the Adco SFS AquaShed Cover # 290-46003 which measures 168" long x 94" tall x 80" wide (at the top and 104" wide (at the bottom for the fenders). This takes into account both the height and the width of your trailer and it provides great protection especially against moisture.

I have attached a review video for you to check out.

expert reply by: Jon G

0

Answer 1

For your application you need the Adco SFS AquaShed Cover for Bumper Pull Trailer #290-46004. This fits trailer boxes up to 16' long which it sounds like that's what you have. This is designed for horse trailers which have the V-Nose same as…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

Ernest, I completely understand why you are asking before ordering because once you get into the heavier #13 Torflex axle setups, a wrong fit can turn into a frustrating and expensive project pretty quickly. Dexter does not currently offer a…

view full answer...

Answer 7

The best cover we have for the dimensions of your trailer is going to be the Adco SFS AquaShed Cover for Bumper Pull Trailer #290-46003 which is designed for trailers up to 14 feet in length, is 9 feet wide, and 8 feet tall so it will match your…

view full answer...

Answer 8

Yes, the sides of the Adco SFS AquaShed Cover for Toy Hauler Travel Trailer #290-52272 that you referenced can be removed to give access to side doors on the front or rear of a travel trailer. On the side there is a front and rear panel that can be…

view full answer...

Answer 9

You are going to need to replace your tail lights on your 2006 Karavan trailer with the LED Combination Trailer Tail Lights #STL57RB & #STL56RB. I was unable to find any information on your specific Wesbar tail lights as the information you…

view full answer...

Answer 10

I do have a couple options that will work for you, but unfortunately there isn't one perfect option that provides everything you are looking for. I have included the options below, along with some of the things that make them work or not work for…

view full answer...

Answer 11

The Adco SFS AquaShed Cover for Bumper Pull Trailer part #290-46004 would be an excellent option for a 7 x 14 V-Nose Enclosed Trailer. The Adco SFS AquaShed Cover for Bumper Pull Trailers is actually designed for horse trailers but it will work well…

view full answer...

Answer 12

Hi Tom, We have two axles rated for 3.5K that have an 85" hub face measurement, but they have different spring seat measurements. The Lippert Beam Only Trailer Axle part #LC93PK has a 70" spring center to spring center measurement and fits…

view full answer...

Recommended Cover for 7x14 V-Nose Motorcycle Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching