Does the Vinyl Trim Insert Need To Be Pushed Flat When Measured
Updated 08/20/2020 | Published 09/01/2019 >
Question:
After looking over all the QandA still not sure what trim to order. I have a 2005 Jayco Granite Ridge motor home. The exterior trim has cracked and come off. The old trim is approximately 3/4 inch wide but is humped up in the middle creating a crown effect. It appears all of the trims you offer are flat. I am not sure if the rounded part of the trim is factory original or if the flat trim has humped up over time. The trim is fairly hard, not soft and supple. If forced to go completely flat would probably be an inch wide. The vinyl has hardened over time so I am guessing the original was probably flat maybe 1 inch wide and naturally had some hump to it when installed at the factory. The rail it fits in is about 1 1/8 inch wide with a slot about 5/8 inch wide plus the side slots that the trim fits into.
asked by: Robert E
Expert Reply:
It is not uncommon for the trim insert pieces to deform over time as they sit inside the channel. When ordering a replacement, it is best to press the hump flat and then measure the width once this is done. I would be willing to bet you are going to get around 7/8" wide while pressed flat and if that is the case then you are going to want to go with a 1" wide replacement, part # CAM25202, part # CAM25222, or part # CAM25192.
Product Page this Question was Asked From
Camco RV Vinyl Trim Insert - White - 100' Long x 1" Wide
- RV Trim
- Insert Trim
- 1 Inch Wide
- Vinyl
- 100 Feet Long
- White
- Camco
more information >
Continue Researching
- Shop: Trailer Wiring
- Shop: Camco RV Vinyl Trim Insert - White - 100' Long x 1" Wide
- Shop: Camco RV Vinyl Trim Insert - White - 100' Long x 1" Wide
- Q&A: Will the TowSmart Hitch # TS67ZR Fit My 2024 Honda CR-V Hybrid Model?
- Search Results: gutter parts rv trim
- Search Results: 18144
- Shop: B&B RV Outdoor Shower Box - 11" Wide x 6" Tall - White
- Shop: RV Rain Gutter Spouts - Polar White - Qty 4
- Shop: Camco FasTen RV Leveling Blocks w/ Carrying Handle - 8-1/2" x 8-1/2" - Gray - Qty 10
- Video: Camco FasTen RV Leveling Blocks w/ Carrying Handle Feature Review
- Shop: Suspension Enhancement
- Video: Air Lift Vehicle Suspension - Rear Axle Suspension Enhancement - AL88138 Review
- Q&A: Recommended Replacement Trim Inserts For An Enclosed Trailer
- Q&A: Trim Molding Needed for Motorhome
- Q&A: Will SuperSprings Fit 2013 Ford F-250 or F-350 Without Factory Overload Springs
- Search Results: vinyl insert trim
- Search Results: insert trim
- Search Results: rv trim
- Search Results: bathroom faucet rv faucets
- Shop: Phoenix Faucets Wall Bracket for RV Handheld Shower Heads - Chrome
- Shop: Premium RV Vinyl Insert Trim Molding - 25' - White
- Search Results: trailer hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)



Bob S.
8/9/2020
I am installing the vinyl trim strip and it goes around the 4 corners! When installed the strip humps as the inside is less distance than the outside of the corner! How do I install so it stays flat around the corner! This happened on all the old strips in time that's why I'm replacing it! One person suggested a heat gun but nor sure about that