1988 Holiday Rambler Replacement Landing Gear Selection

Published 07/25/2019

Products Featured in This Question

Landing Gear Set - 36-1/2" Lift - 8,000 lbs

(768)

$340.08

Ultra-Fab Deluxe Electric Landing Gear Set - Weld On - 38" Lift - 12,000 lbs

(281)

$1127.98

Question:

Recently purchased a 1988 HR 5th Wheel Alumilite Trailer. The landing gear either broke or quit previous owner had just fixed one side. I know little to nothing but it looks like the RVLG 8000 should work. If not, could you tell me what you have that would work? Thanks.

asked by: Krystal R

Expert Reply:

In order to pick out a direct replacement for the landing gear on your 1988 HR 5th Wheel Alumilite Trailer we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the etrailer landing gear part # RVLG-8000. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # RVLG-8000.

I attached a picture that shows the dimensions that this landing gear set would fit with.

The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine. This is by far the most popular setup seen on trailers.

If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.

expert reply by: Jameson C