Replacement Reese Sway Control Friction Pads for Reese SC Weight Distribution System Part RP66153

Question

Question:

Will part no. 58512 go with reese hitch RP66153 Thanks,

asked by: David M

1

Helpful Expert Reply:

Yes, the Replacement Reese Sway Control Friction Pads with Screws part # 58512 will work with your Reese SC Weight Distribution System part RP66153. These are the same pads that would have came with the system from the manufacturer.

expert reply by: Conner L

1

Answer 1

The Reese Steadi-Flex Weight Distribution System w/ Sway Control - Trunnion - 10K GTW, 1K TW #RP66559 utilizes friction pads that will eventually wear down as you stated. It will take a long time for these pads to require replacing, but the…

view full answer...

Answer 2

We do offer replacement friction pads for the Reese SC Weight Distribution/Sway Control system. The pads alone are offered in a set of four and include the mounting screws. The pads measure 1-23/32-inches long x 7/16-inches thick. This is part…

view full answer...

Answer 3

We offered those replacement parts at one time, but unfortunately, Reese discontinued the Reese SC in 2018, and any stock they had of replacement parts has long since been cleared out. Reese's replacment for the SC is the Steadi-Flex. The highest…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Replacement Reese Sway Control Friction Pads for Reese SC Weight Distribution System Part RP66153

Continue Researching