Is Drilling Required To Install the Roadmaster Rear Anti-Sway Bar On a 2015 Ford F-250

Published 06/30/2019

Question:

2015 Ford F250, 6.2L Gas, short bed, 4x4 - no factory sway bar. Is there any drilling or is this completely bolt on including the end link kits? One of the reviews mentions drilling some ½ inch hole....

asked by: Darryl

Expert Reply:

The Roadmaster Rear Anti-Sway Bar and End Link Kit part # RM-1139-173-00 is a custom fit for your 2015 Ford F-250 which means there is no drilling required. I checked with Roadmaster to confirm this for you. There are brackets welded to the axle for the sway bar to attach and then pre-drilled hole in the frame for the end links to attach.

The review that you were referencing was not on the same Roadmaster Rear Anti-Sway Bar and End Link Kit listed above but rather one similar in which the holes for the sway bar end links were not present so drilling was required but this will not be the case for you.

expert reply by: Conner L