How to Remove Face Plate on the Jensen RV Stereo # JWM70A
Updated 07/07/2020 | Published 06/24/2019
Question:
Trick to remove face plate
asked by: Robert Z
1
Helpful Expert Reply:
There are actually a series of screws on the Jensen RV Stereo # JWM70A that keeps the face plate in place. In order to remove it you need to first remove the screws.
Attached is a photo from the back side of the stereo where you can see some of the screws.
expert reply by:
Jon G
1
click to enlarge
Continue Researching
- Shop: Lippert Replacement Motor with Brake for In-Wall RV Slide-Out - Mid Torque
- Q&A: Warranty of Lippert LC364262 Replacement Motor with Brake for In-Wall RV Slide-Out
- Q&A: Options For Replacing A Jensen JWM72A
- Shop: Fifth Wheel Hitch
- Shop: MORryde Quick Connect RV Steps for 35-1/2" to 44" Entry Height - 4 Steps
- Q&A: Replacement Vent Cover for Vent With Continuous Metal Hinge
- Q&A: Which Access Toolbox Edition Tonneau Cover Fits 2024 Ford F-350 Long Bed
- Shop: MORryde Flip Tread RV Steps for 23-3/4" to 28-1/4" Wide Doorways - 4 Steps
- Q&A: Is There A Gooseneck Hitch Which Will Not Void The Lippert Limited Frame Warranty On a 5TH Wheel?
- Q&A: Do Fifth Wheel to Gooseneck Hitch Adapters Void Trailer Warranty
- Shop: MORryde StepAbove RV Steps with Strut Assist - 23-3/4" to 24-1/4" Wide Doorways - 4 Steps
- Video: Complete Breakdown of the MORryde Quick Connect RV Steps for 35-1/2" to 44" Entry Height
- Shop: Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride Coupler Adapter - 20,000 lbs
- Shop: B&W Companion 5th Wheel Trailer Hitch - Dual Jaw - 20,000 lbs
- Shop: B&W Companion OEM 5th Wheel Trailer Hitch w/ Slider for Ram Towing Prep Package - Dual Jaw - 20K
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Video: Detailed Breakdown of the Access Toolbox Edition Soft, Roll-Up Tonneau Cover
- Search Results: tool box compatible tonneau cover
- Search Results: auto leveler
- Search Results: tonneau cover
- Shop: Tonneau Cover
- Q&A: How Does Lippert Replacement Motor with Brake for In-Wall RV Slide-Out Fit
Joe K.
7/2/2020
I think what Robert Z was asking is how to remove an installed unit, which I need to do also. You would start by removing what looks like a snap-on frame around the operational face plate. It looks like there is a small tab on the right side of the face plate in the picture you used; does it just pry off?