Will The Thule Knob 753-0745 Fit A m6 Bolt

Question

Question:

hi, is there a nut inside the knob, and if so, will it fit the m6 bolt? Thx

asked by: Greg L

0

Expert Reply:

Yes, there is a nut inside of the knob part # 753-0745 that fits a m6 bolt confirmed by a test fit. I have attached a photo that shows the nut inside of the knob a bit more clearly.

expert reply by: Heather A

0

click to enlarge

Answer 1

It sounds like you are wanting the Replacement 3-Wing Hand Knob for Thule Bike, Board and Ski Carriers #753-0745. This is a replacement part for the Thule Glide and Set Rooftop Kayak Carrier System with Tie Downs TH883.

view full answer...

Answer 2

In order to have all your Thule lock cores keyed alike, all the locks should use the same lock core. The number on the lock is the key number. If one of the locks you've got has the number "N082" stamped on it, and you'd like…

view full answer...

Answer 3

Would you be able to send me some photos of your roof box and the area where the mounting hardware is installed? If you have a newer Thule/MB cargo box then the Replacement Quick Grip Mount Assembly #TH05738 should work but if I could see some photos…

view full answer...

Answer 4

I can absolutely tell you the difference between Yakima OutPost HD Overland ladder rack and the Yakima OverHaul HD ladder rack, and both are indeed available with 68 inch crossbars, as well as a tonneau cover adapter with the following parts: -…

view full answer...

Answer 5

You will need the Replacement M6 x 35 mm Tamper Proof Screw #TH93PH for your Thule Universal Flat Top Ski Rack 91725B. This screw is 3/16" longer than the Screw #853-5269 you found. We do also have the Tamperproof Wrench #853-5270-02 to tighten…

view full answer...

Answer 6

Hello Jordan, thanks for reaching out. In order to use the Thule Motion XT Rooftop Cargo Box #TH629806, your crossbars must be between 23-5/8" and 36-7/8" apart. Also, for the hitch to fully open, you must have at least 51-1/4" from…

view full answer...

Answer 7

Hello Howard. If you're planning on removing your roof rack completely you will need to drill into your roof to install another type of rack. The Rhino-Rack RT Style Roof Tracks #RRRTS502F will give you a lot of options for roof racks once…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Will The Thule Knob 753-0745 Fit A m6 Bolt

Product Page this Question was Asked From

Continue Researching