Replacing the Jensen Stero JCD3007 with a Jensen Stero JWM10A
Updated 05/15/2019 | Published 05/13/2019
Products Featured in This Question
Question:
I would like to change out the old Jensen JCD3007 in my trailer with the new JWM10A. Is this a straight forward swap or is there some additional info I should be aware of? Thanks
asked by: Alan
Helpful Expert Reply:
The Jensen RV Stero part # JWM10A that you referenced requires around a 11" wide x 3" tall cutout which is fairly standard for single din stereos so there should not be much issue here. In regards to wiring, you will need to remove the pigtail you have used to install the Jensen RV Stero JCD3007 and replace this with the one that comes with the above using butt connectors part # DW05744-10 and part # DW05744-5. I have attached the pin-out diagram of each pigtail for you which should make the swap pretty easy.
Continue Researching
- Search Results: break controller
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Empire Faucets Hybrid RV Tub Faucet and Shower Head - Dual Knob Handle - Chrome
- Search Results: thetford 42072 toilet parts
- Shop: Jensen Mechless RV Stereo - Single Din - Bluetooth - 2 Zone - 12V
- Shop: Brake Controller
- Shop: Trailer Wiring
- Shop: Deluxe Compartment Door Key Lock - 7/8"
- Shop: Cam Lock for B&B RV Compartment Door - Offset Blade - 1-1/8" Cylinder - Chrome - 391
- Shop: Cam Lock for B&B RV Compartment Door - Offset Blade - 5/8" Cylinder - Chrome - 391
- Shop: Lippert Baggage Door Turn Latch - 7/8"