Replacement Venture Gear Box for RV

Question

Question:

Gearbox Atwood RV leveler 66375 was wondering if there was a gearbox that I could purchase that may have been re-furbished

asked by: Daniél

0

Expert Reply:

Thanks for the picture of your gear box. For an exact replacement we have the # LG-179015 that you referenced which is a brand new gear box. We do not carry refurbished units.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I would check the magnets for wear before going on to test them with a meter. If the magnets show abnormal wear or if you can see the windings beginning to show through the friction surface of the magnet then they will need to be replaced. To further…

view full answer...

Answer 2

Since the trailer was off of the ground it would not take much voltage to stop the wheels from spinning so they may be getting power but they may not be getting enough power due to a short or wiring issue. But 9 times out of 10 weak trailer brakes…

view full answer...

Answer 3

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Answer 4

If your motor runs but the landing gear does not move (except when manually cranked) this suggests that the gearbox in the landing gear is still functioning properly but that there is some issue preventing the motor torque from reaching the gearbox.…

view full answer...

Answer 5

Thanks for the pictures. You won't need to replace the entire landing gear set. For your Venture landing gear on your 2002 Forest River Cedar Creek Fifth Wheel you will want item #LC119102 for the lead leg or item #LC119101 for the follow leg.…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Replacement Venture Gear Box for RV

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching