D-Ring Anchor Point With Diameter of 3/4 inch Availability

Question

Question:

Do you have a part that is exactly like this one except with a smaller ring diameter preferably not larger than .787 inch cross section?

asked by: Michelle T

0

Expert Reply:

The D-Ring we offer with the closest diameter to .787 inch is the # C83760 which has a diameter is 3/4 inch. This has a max load capacity of 26,500 lbs.

expert reply by: Jameson C

0

Answer 1

The two base pieces of the Buyers Products 1" Forged 360 D-Ring #337B51 get welded to the mounting surface and to each other but the D-ring itself does not which allows it to pivot as needed. Basically once the base pieces are weld in place they…

view full answer...

Answer 2

That specific info isn't listed. Basically Buyers Products states that the welding procedure for the #337B51 should be in accordance with those published by the American Weld Society or other technical groups. All welding personnel should be…

view full answer...

Answer 3

We have the Buyers Products 5/8" Forged D-Ring With 4-Hole Integral Mounting Bracket #337B40MP which is made in the USA. Most of the Tie-Down Anchors we carry are made overseas but there are a few exceptions with most of them being weld-on only.…

view full answer...

Answer 4

This Buyers Products 1" Forged 360 Rotating D-Ring With Weld-On Mounting Bracket #337B51 normally fits in a 3 inch diameter hole.

view full answer...

Answer 5

Congratulations on the HHR purchase James and thank you for sending the photo! Based on what I can see, your base plate appears to use Blue Ox's tabs and looks very similar to the Blue Ox Base Plate Kit #BX1692 used on the 2006-2011 Chevrolet…

view full answer...

Answer 6

John, that is a completely valid concern, especially since you already went through the trouble of switching from the horizontal air distribution box to the lateral version just to improve airflow throughout your R Pod. The last thing you want is to…

view full answer...

Answer 7

Hey Keith! I can definitely help you find a replacement for your Dometic Duo Therm. However, you're going to have to replace the thermostat and air distribution box as well. Your current setup is for R410A and everything switched to R32 last year…

view full answer...

Answer 8

Hey Michael, congrats on the new truck. The Ford puck systems haven't changed since they came out in the 2010-2011 model year trucks. The Curt Pop-In Ball for Factory Chevy/GM, Ford, and Nissan Underbed Gooseneck Hitches item #C60629 you were…

view full answer...

Answer 9

Hey Joe, thanks for all of the details you mentioned. The Bulletproof Hitches Safety Chains part #BPH94MR that you referenced would be exactly what you are looking for. These are 38 inches long and are 5/16 inch in diameter as well. For a set of…

view full answer...

Answer 10

For replacement Blue Ox Base Plate tabs we have the following: Tab Assemblies for Blue Ox Baseplates - Short Front/Short Back - #BLU57XR Tab Assembly for Blue Ox Baseplates - Short Front/Long Back - #BLU37XR Tab Assemblies for Blue Ox Baseplates -…

view full answer...

Answer 11

Yes, you will! We get this question all the time. Even though there's a 12 v power wire ran to the back you still need a dedicated one run directly from the battery for the Tekonsha item #118786 or the Curt item #56407. The power module's are…

view full answer...

D-Ring Anchor Point With Diameter of 3/4 inch Availability

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching