Can Air Lift WirelessONE Compressor System be Connected to Upfitter Switch on Ford F-250

Question

Question:

Can this unit be installed using the factory installed Ford upfitter switches? The thought would be that when the upfitter switch is on, that just provides power to the unit to then be controlled with the remote.

asked by: Aaron S

0

Expert Reply:

Since the Air Lift WirelessONE Compressor System # AL25980 automatically restores air in the air bags when it senses that the pressure falls below what you have selected I don't recommend connecting the power from this unit to an Upfitter switch on your Ford F-250. Yes it is technically possible to do so but that means you would have to leave it on to ensure that the your bags stay at the determined air pressure.

The best option is to just wire the power directly to your battery and then use the remote control to adjust your air bags.

expert reply by: Jon G

0

Answer 1

Hey Mark, the Air Lift WirelessONE part #AL25980EZ does have an inlet air filter but the part #AL25980 does not.

view full answer...

Answer 2

Hi Duane, Air Springs are better for leveling loads and will typically give you a rougher unloaded ride quality so these might not be the best option for your setup depending on what your intended use is. Air springs are the best option when it comes…

view full answer...

Answer 3

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 4

It sounds like the compressor system may not be getting power or is not waking up. Depending on how the Air Lift WirelessONE Compressor System #AL25980 is wired to your vehicle you may have to do additional steps. The wiring harness has a ignition…

view full answer...

Answer 5

Hey Ron, since we have found that the Firestone air bag kits like the part #F95FV are the highest quality and best performing this is what I would recommend for your 2026 Ford F-250 that will be towing heavy very regularly. Then for a heavy duty…

view full answer...

Answer 6

Hey Doug, thanks for the information and congrats on your protentional new trailer. The only way to mount a 5th wheel hitch in your 2024 Toyota Tundra Hybrid is to install the B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom…

view full answer...

Answer 7

Good choice with the B&W Turnoverball #BWGNRK1108, Howard! It's definitely the way to go. With that installed on your 2007 Ford F-250 4 wheel drive you will want the Firestone Ride-Rite Air Helper Springs #F2400. These will absolutely work…

view full answer...

Answer 8

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Answer 9

Since you have a 2 wheel drive version of the 2018 Ford F-250 the correct Air Lift LoadLifter 5000 is the part #AL88391 as the part #AL88399 is for the 4 wheel drive versions. Both of these are compatible with in-bed hitches like your Turnoverball as…

view full answer...

Answer 10

I would be happy to help you find out what is causing the driver side Air Lift LoadLifter 5000 Air helper spring to deflate while the passenger side spring does not. You are on the right track by using the soapy water mixture to find where the leak…

view full answer...

Answer 11

When wiring up the Air Lift WirelessONE Compressor System for Air Helper Springs - Remote and Mobile App #AL25980EZ the power wire needs at least 15 amps to power the unit and the keyed power source that runs to the ignition switch circuit needs at…

view full answer...

Can Air Lift WirelessONE Compressor System be Connected to Upfitter Switch on Ford F-250

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching