bing tracking image
Q & A Icon

Troubleshooting Auto-Leveling System on Thor ACE  

Updated 09/19/2026 | Published 12/15/2018

Question:

Automatic leveling system are all fully retracted. When I start the vehicle all of the warning lights continue to flash on the control panel. How do I reset the control panel? No of the buttons respond and I am not able to lower any of the jacks manually or automatically. I turn off the engine and whenever I restart it all the warning lights on the leveling control panel come back on.

0

Expert Reply:

I recommend disconnecting 12V electrical power from the main system control panel for a few minutes. Usually about 15-minutes without power does it.

Once reconnected to power if you still have error codes, such as "Out-of-Stroke", to clear this code you can extend all of the jacks in the system at least 6 inches. Then press and hold the retract button until the jacks start to retract. All of the jacks should fully retract and the error should be cleared.

If this process does not correct the issue then please tell us the part number and serial number from your control panel and any messages that appear on its display and we can work with Lippert to find a fix or the correct replacement part, such as a Control Panel # LC175225.

You should still be able to manually lower the jacks by selecting manual mode and using the hand crank.

expert reply by:
0
Adam R
Mark profile picture

Mark

6/15/2025

I have the exact error issue. It's on a Thor motor home 30 ft. I replaced the engine battery and the strut control panel is just beeping. All the lights are flashing and no buttons work,not even the off/on. I noticed on the rear the drivers side is lower than the other. Can you please advise? Thanks

Jameson C. profile picture
Etrailer Expert

Jameson C.

6/16/2025

@Mark Did you cut power to it to reset it like Adam mentioned?
Ryan profile picture

Ryan

6/18/2025

@Mark Hold all four directional arrows down for 1-2 seconds. The blinking should stop and the buttons should work again.
Jameson C. profile picture
Etrailer Expert

Jameson C.

6/18/2025

@Ryan Thanks for that tip!
Mark profile picture

Mark

6/15/2025

Also you mentioned disconnecting the 12amp supply. Does disconnecting the battery service the same? Thanks

Jameson C. profile picture
Etrailer Expert

Jameson C.

6/16/2025

@Mark Yes it would.
Brian B. profile picture

Brian B.

9/19/2026

My 2016 Thor ACE LCI leveling system has the left arrow blinking and the Jacks Down light on, but all jacks are up. I tried pushing Retact Jack button and nothing happens. I’ve tried the 4 button reset and disconnecting the battery and I still get the same lights. Any suggestions?

Heather A. profile picture
Etrailer Expert

Heather A.

9/19/2026

@BrianB On a 2016 Thor ACE with the LCI hydraulic leveling system, a blinking left arrow and “Jacks Down” light when the jacks are fully up usually points to a power issue, a tripped high amp breaker, or a hydraulic pressure issue. Since the panel is not responding to Retract, I’d first check the main high amp breaker and make sure your 12 volt battery voltage is strong, then check the hydraulic fluid level with all four jacks fully retracted. If those check out, the system may need to be rehomed to clear the error.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>