How to Permanently Install the Camco Olympian Wave 3 Heater Part # CAM57331

Published 11/06/2018

Question:

Hello, Do you sell a hose/ hardware kit to tie into an existing LP supply line source furnace, cooktop , water heater, refrigerator to be able to supply LP to the Wave 3. Thank you,

asked by: Ken

Expert Reply:

If you will be permanently installing the Camco Olympian Wave 3 Catalytic Safety Heater part # CAM57331 then you would need to run a hose from the heater to the propane manifold. I cannot recommend you tap or splice into an existing line. The fitting on the end of the heater is a 3/8" male flare. You would then need a hose with a female 3/8" flare and then whatever is on your propane manifold. Since you will need to possibly alter or connect to the propane manifold on your trailer I highly recommend you contact a local RV dealer for installation. We would not have the parts needed to connect to the propane manifold.

I have attached a photo below to show the process.

expert reply by: Conner L