Replacement Adjustment Handle for Ram Adjustable Gooseneck Coupler GCSQTW-30008

Question

Question:

The jack handle to raise or lower the neck is froze and wont turn. How can I free it up

asked by: Luke H

0

Expert Reply:

If the coupler will not adjust be sure that the set screw (shown in the linked photo) has been loosened to allow the coupler to move. If the set screw has been loosened and the unit will not adjust try applying a product like PB Blaster or WD40 to the set screw hole with the unit upside down so that it can flow down into the mechanism. This might help loosen up the adjustment function.

If you need just a Replacement Topwind handle assembly for your Ram Adjustable Gooseneck Coupler # GCSQTW-30008 we do offer a handle kit # GCSQTW-30008-HD.

expert reply by: Adam R

0

click to enlarge

Answer 1

The Gooseneck Trailer Coupler part #LL2516ST and Ram Gooseneck Coupler part #GCSQTW-30008 both have a 4" wide inner tube with similar topwind handle. Therefore, in theory you should be able to swap the inner tube out between one another. That…

view full answer...

Answer 2

I reached out to the company that builds the Ram Gooseneck Coupler item #GCSQTW-30008 , Pacific Rim International Factory, and was not able to get an exploded parts diagram. I have listed all of the replacement parts below that are available.…

view full answer...

Answer 3

Hey Weston, gooseneck couplers aren't super refined and since they are also adjustable it's not unheard of for there to be some play due to looser tolerances. Now I don't know what specific coupler you have but as long as the bolts are…

view full answer...

Answer 4

I do have an option for you but we don't offer any inner tube square gooseneck couplers which measure 3-1/2" x 3-1/2" as this is not a standard size. That said, what you can do is install a new outer tube and inner tube of the standard…

view full answer...

Answer 5

Hello Jerry, Great question. It all depends on on if it is compatible. If your current set up is not a topwind coupler then it isn't going to work because the #GCSQTW-30008 does not use traditional pin-adjustment holes (please refer to picture I…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Replacement Adjustment Handle for Ram Adjustable Gooseneck Coupler GCSQTW-30008

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching