Internal Dimensions of NOCO Commercial Grade Battery Box # 329-HM484

Question

Question:

Does this box hold 2 batterys?

asked by: Edwin J

0

Expert Reply:

The internal dimensions of the NOCO Commercial Grade Battery Box # 329-HM484 that you referenced is 21" long x 11-13/16" wide x 10-5/16" deep which could possibly carry two batteries, but it really depends on the size of the batteries. It was intended for two smaller sized batteries.

expert reply by: Jameson C

0

Answer 1

Sounds like you are wondering if the Tow-Rax Corner Helmet Shelf #TWSPCHH has angled brackets on the back of it that would match the angles of your V-nose trailer. If the angle of your V-nose trailer is right at 90 degrees then this would match right…

view full answer...

Answer 2

I've drawn up a little diagram below of the Hughes Autoformers Safe View Smart Power Inlet #HU87VR dimensions. Based on what I found a 3-1/2" round hole would be a bit too large and would require you to first place some sort of cover over…

view full answer...

Answer 3

Great question, lets have a look at this unit and see what we can figure out. **Commercial Grade Battery Box for Group 8D Batteries - Vented #329-HM484. *TorkLift PowerArmor Locking Battery Box - 6V and 12V Lithium Batteries - Powder Coated Aluminum…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Internal Dimensions of NOCO Commercial Grade Battery Box # 329-HM484

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching