Recommended Air Springs Air Compressor System with 100 PSI Gauge

Question

Question:

I already have a VIAR compressor/tank on the truck. I just need to know if I can get the gauge in 100 psi?

asked by: Brett

0

Expert Reply:

For your Air Bags on your truck, I recommend the Air Lift Load Controller II Compressor System for Air Helper Springs - Single Path # AL25592. This will give you a single gauge that will read up to 100 psi as requested and fill your air bags equally side to side. This system will allow you to adjust the level of your air springs at any time from the comfort of your cab. I've attached a video of this installation to assist.

expert reply by: Jason S

0

Brett

6/11/2018

I already have a VIAR compressor/tank on the truck. I just need to know if I can get the gauge in 100 psi?

Jason S.

6/11/2018

The Replacement Air Gauge for Air Lift Load Controller Compressor System # AL25194 is the only gauge we have that goes to just 100 psi. If you want a gauge that goes to 150 psi without any switches, then the In-Cab Air Pressure Monitoring Gauge - White Face # F2196 is a great option. If you want the switch as well then use # F2435829195.

Answer 1

Thank you for your question! We have some air bag kits that are compatible with 5th wheel base rail kits but I would need to know what brand base rails you have on your 2000 Ford F-250. If you could let me know or send me a picture of the base rails…

view full answer...

Answer 2

Hello Nick, thanks for reaching out. To answer your first question, coil helpers like the Firestone #F4155 will not raise your Sienna beyond the factory ride height. If the hitch and bike rack are causing some squatting, the air bags will help to…

view full answer...

Answer 3

No, It does not because item #AL25804 is for air shocks but I have one that does. The Air Lift Load Controller II Compressor System for Air Helper Springs item #AL25592 has a minimum pressure setting of 5 psi which can be adjusted to 10 psi.

view full answer...

Answer 4

You can indeed use both an air suspension and weight distribution in tandem. We advise folks to air the bags to the desired level, then set up the weight distribution system according to the instructions. Not everybody agrees, some will state the…

view full answer...

Answer 5

The Jayco Eagle Superlight is rated at GVWR of 10,200 lbs. There are only certain combinations of a 2016 Ram 1500 4x4 with 5.7L Hemi that will pull that much weight. Here are the 4x4 combinations that work: Quad cab 6ft 4 inch box with 3.92 axle…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Recommended Air Springs Air Compressor System with 100 PSI Gauge

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching