Will Mounting Bolt Pattern On a Bulldog A-Frame Jack Match the Bolt Pattern On a Fulton A-Frame Jack
Updated 08/29/2011 | Published 08/28/2011
Question:
I need to replace a Fulton 3000lb jack and thinking buying a Bull Dog 3000lb. My question is this, are the bolt paterns the same for all A-Frame?
asked by: Mark
Expert Reply:
All A-Frame mounted jacks like the Bulldog Round A-Frame Jack, part # BD1550101344, use the same 3-inch mounting hole bolt pattern. In other words, the mounting holes are a universal size and pattern so that any A-Frame jack will fit into any A-Frame jack mount. As long as your trailer has an A-Frame jack mount, this jack will fit.
You will want to make sure and replace your current A-Frame jack with a jack of similar specifications with a lift capacity the same or higher.
Continue Researching
- Search Results: hydraulic jack
- Q&A: Topwind Trailer Jack vs. Sidewind Trailer Jack for A-Frame Trailer
- Q&A: Is a Support Plate Needed When Installing Bulldog A-Frame Trailer Jack # BD1550101344
- Q&A: Short Trailer Jack Recommendation for a 7000 lb A-frame Horse Trailer for Tailgate Clearance
- Q&A: Corrosion Resistant A-frame Jack Needed for a Boat Trailer Used in a Salt Water Marine Environment
- Q&A: Required Bolt Length for Installing A-Frame Trailer Jack
- Q&A: Recommended A-Frame Trailer Jack for 7000 lb Trailer
- Q&A: Outer Tube Diameter of the Stromberg Carlson Replacement Foot Pad # 2500-3755G
- Article: Big Truck Big RV
- Article: Trailer Maintenance Schedule
- Article: Trailer Jacks
- Article: How to Raise Your Travel Trailer Height
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Lighting Requirements