How to Determine if Fulton Trailer Fender # F008551 Will Fit Existing Mounting Brackets

Question

Question:

I have a karavan pwc trailer. How can I be sure if the fender linked below will fit my mounting brackets? F008551

asked by: Frank P

1

Helpful Expert Reply:

The Fulton Single Axle Trailer Fender # F008551 referenced in your question features overall dimensions of 7.35 inches wide, 21-1/2 inches long, and 6-1/2 inches tall. In order to determine if this will install on with your existing mounting brackets, you will just need to compare their measurements to what this fender will work with.

On this fender, there is a distance of right at 2-1/2 inches between the mounting slots, on center. The slots themselves measure 1/2 inch x 1/2 inch. I have attached a couple images with these and additional dimensions labeled so you can get a better idea as to how it will install. I have also attached a short video demonstration on this fender that you can check out.

expert reply by: Chris R

1

click to enlarge

Answer 1

The recommended brackets to use with the Fulton fenders part #F008551 is the #CE26061G-2. I attached a picture that shows how a customer used these brackets with this fender for you to check out as well.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

How to Determine if Fulton Trailer Fender # F008551 Will Fit Existing Mounting Brackets

Featured Help Information

Miscellaneous Media

Continue Researching