Which Draw-Tite Class II Trailer Hitch Will Fit On a 2007 Toyota Camry SE V6

Published 08/08/2011

Products Featured in This Question

Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(225)

$237.57

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(258)

$61.61

1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs

(2621)

$16.53

2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs

(2621)

$18.47

Drawbar for 1-1/4" Hitch - 2-5/8" Rise, 3-1/4" Drop - 7-3/16" Long - 3.5K

(2328)

$29.12

Pin and Clip for 1-1/4" Hitches - 1/2" Diameter

(895)

$11.49

Question:

Will the Draw-Tite Class II Trailer Hitch Fit On the 2007 Camry SE V6 Will I have problem intalling this to a Camry V6/

asked by: Jon T

Expert Reply:

Yes, the Draw-Tite Trailer Hitch, # 36416, will fit your 2007 Toyota Camry SE V6. Installation of this hitch requires drilling and temporary lowering of the exhaust. But if you have the necessary tools and a helping set of hands, you should be able to install the hitch yourself. I have included a link to the installation instructions and a link to a video showing a typical installation for you to view.

If you are planning to do some towing, the recommended ball mount is # 36071 and you can use pin and clip # PC2. For a ball you can use # 19256 (1-7/8 inch diameter) or # 19258 (2 inch diameter). For trailer wiring, use # 118405. I have included a link to the installation details for the wiring as well.