LED Trailer Tail Light Recommendations for a Boat Trailer
Updated 08/02/2011 | Published 08/01/2011
Products Featured in This Question
Question:
Would these lights work for tail lights for my boat trailer?
asked by: Adam
Expert Reply:
The Sealed, Miro-Flex, Thin Line, LED Lights, # MCL63CRB, are DOT approved as Trailer Marker, Clearance or ID Lights only, so you would not be able to use them as tail lights.
A similar light in shape and size that would work for you is the Miro-Flex, Waterproof, Rectangular, LED Trailer Light, # STL33RB. You would also need a wiring harness like # A45PB, and a grommet, # A33GB.
Or, if a rounded light is acceptable, you can go with # STL70RB, with wiring # A45PB and Grommet # a70gb.
Product Page this Question was Asked From
Miro-Flex Thinline LED Trailer Clearance or Side Marker Light - Submersible - 4 Diodes - Red LEDs
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 4L x 1W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Troubleshooting Stillwell 7k Hydraulic Jack that Raise/Lower
- Q&A: Will Advent Air Distribution Box ADV48SR Work With Advent ACM135
- Q&A: Do Slipper Springs Use Bushings on Both Ends?
- Article: Trailer Lighting Requirements
- Q&A: Replacement Trailer Vent Cover Lid for Wells Cargo Road Force Cargo Trailer
- Q&A: Dimensions Of Gen-Y Shock Absorbing 5th Wheel to Gooseneck Pin Box GY66FR
- Q&A: Can Single Rocker Switch # 37212625 be Used with 12 Volt DC Power
- Q&A: What Is The Shoe In A Schwintek Slide Out System And What Does It Do
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Motorhome Steps
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today