Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Switching to LEDs makes a big difference in brightness and efficiency. This Miro-Flex thinline trailer light uses 4 red LEDs that put out strong, even light while only drawing 0.051 amps at 12.8V. The faceted Miro-Flex reflector boosts output and gives it a clean, modern look. You get bright visibility with far less power use and no fragile bulbs to worry about.
Water damage can kill a light fast, but this one’s built to handle it. The housing and clear lens are sonically sealed into a single waterproof unit, keeping moisture completely out. It’s submersible, so even if your trailer gets dunked at a ramp or splashed on rough roads, the LEDs stay protected and working like new.
When space is limited, the slim Thinline design fits where bulkier lights won’t. Measuring just 4-1/16" long, 1-1/4" wide, and 1-1/8" thick, it mounts neatly to the surface using a bracket (A65B – sold separately). It accepts standard 1- or 2-prong plugs (A65P or A68P – sold separately), making wiring simple and clean without extra hardware fuss.
Visibility matters when you’re on the road, and this light’s P2 rating delivers a 45-degree beam to either side of center for dependable coverage straight on. It functions as a clearance or side marker light when properly mounted and meets DOT requirements for trailer lighting. You get consistent performance and safety you can count on every trip.
LEDs last up to 50 times longer than incandescent bulbs, so you can forget about frequent replacements. The polycarbonate housing and lens add extra toughness for long service life, even under rough conditions. Backed by a lifetime LED warranty, this Miro-Flex light is built for lasting reliability mile after mile.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we are going to take a look at Optronics Sealed Miro Flex Thin Line LED Trailer Marker and Clearance Light part number MCL63CRB. This light has a crystal clear lens that is sealed and waterproofed against the housing. Inside are 4 red LEDs that draw a total of .086 amps at 12.8 volts. The LEDs inside are also covered by a lifetime warranty from Optronics. This light is designed to snap into a mounting bracket using the tabs on the side. The mounting bracket will offer a connection for our ground and then we will use the single pole wire lead for our power. Next we are going to hook up this light up to a power supply so you can see how it looks. Next we are going to hook this light up to a power supply so you can see how it looks. Connect our ground connection to one of the prongs at the back and power to the other. Next we will turn off the overhead lights so you can see how bright the light is. And that does it for Optronics Sealed Miro Flex Thin Line LED Trailer Marker and Clearance Light part number MCL63CRB.
Customer Satisfaction Score:
98% were satisfied with this product
2% of customers were not satisfied
Ratings & Reviews
Kyle C.
6/7/2014
which bracket did you use for this light? all the ones ive seen are a little narrower than the actual light so in theory i wouldnt think it would work for this light. thanks
Bryan
11/3/2021
I have to press them back into the bases a little every now and again but its not really an issue. Still bright and looking good. Very pleased.
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Edward R.
11/17/2017
installed on sons 28 ft enclosed trailer works great no problem other people seeing trailer when towing