Cap Recommendation to Hub Bore 2.44 inches
Updated 03/27/2018 | Published 03/26/2018
Question:
I am trying to find the correct size for an older trailer dust cap. The inside bearing cap area was measured with a digimatic digital caliper to be 2.42. I have already purchased 3 caps that are incorrect size. Please can you help?
asked by: Susan
0
Expert Reply:
The closest cap we have to the size you mentioned woudl be the part # RG04-060 which is designed fit a hub bore of 2.44 inches which would be a tiny bit too big for the dimension you listed.
The other sizes we offer are either much bigger or much smaller.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Grease Cap, 2.44" OD Drive In - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 2.44 Inch O.D.
- 2.44 Inch
- 5200 lbs Axle
- 6000 lbs Axle
- TruRyde
more information >
Continue Researching
- Shop: Bearing Buddy Bearing Protectors - Model 2080 - Chrome Plated (Pair)
- Shop: Bearing Buddy Bearing Protectors - Model 2080T-SS - Threaded - Stainless Steel (Pair)
- Q&A: Recommended Trailer Axle Bearing Dust Cap Compatible with 2.10 Inch Hub
- Q&A: How to Measure for the Correct Dust Cap?
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Shop: Trailer Axle w/ Electric Brakes - Easy Grease - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
- Q&A: What Is Included With The Timken Bearing Kit TMK72VR?
- Q&A: What Direction Should The Band on a Leaf Springs Be Faceing
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Snap-On Trailer Jack for Atwood 1,000 lb Snap-On Jack
- Q&A: Parts Needed to Install Solera/Lippert XL Awning
- Article: How to Replace a Rubber RV Roof
- Article: How to Install an RV Awning From Scratch
- Article: Trailer Wiring Diagrams
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Trailer Lighting Requirements