RV Winterization Quick-Turn Water Heater Bypass Kit Recommendation

Question

Question:

I have a PVC valve with male ends, but the male fittings are 3/4. Can you help?

asked by: Barb S

0

Expert Reply:

I spoke with my contact over at Camco and he was very adamant about removing the PVC and using brass fittings that come in one of the kits: # CAM35953 for a 6 gallon water heater or # CAM35963 for a 10 gallon. Apparently the PVC ones do not hold up well.

expert reply by: Michael H

0

Answer 1

We do offer a Camco RV Winterization Quick-Turn Water Heater Bypass Kit that has three male threaded ends, part #CAM35983. This kit includes the valve, backflow preventer, plastic tee, hose, and PTFE thread tape.

view full answer...

Answer 2

I have attached a photo below which shows the proper installation of a three way water heater bypass valve kit like the Camco RV Winterization Bypass Kit part #CAM35953. The female fitting on the bypass attaches to a male fitting on the water heater.…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 7

For replacement Dexter manual adjust brake assemblies to replace your 36-19 you would want the part #23-27 for the right hand side and part #23-26 for the left hand side. These are manual adjust 10 by 2-1/4 inch Dexter brake assemblies that would…

view full answer...

Answer 8

Since the Fan-Tastic Vent Model 6504-414 is out of production what you can do is upgrade the fan with the Fan-Tastic Vent 7350 Series Upgrade Kit - High/Low Style Base - White Item #FV807359. This kit comes with a remote and a bracket you can mount…

view full answer...

Answer 9

Hey Hubert, thanks for reaching out! Normally the rebound clips will face towards the front of the trailer for leaf springs like the 2K #TRU42FR. If you accidentally installed it the other way around, then it won't be a huge deal, but…

view full answer...

Answer 10

I checked with Lippert and the part number you have of 1510000140 corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985. Based on what you described it sounds like the module is bad and…

view full answer...

Answer 11

If you check out the attached instructions for the Curt TriFlex Trailer Brake Controller #C24VV you can see that the OL code you are getting means that there is an "Overloaded output circuit, trailer brake system fault". Whichever…

view full answer...

RV Winterization Quick-Turn Water Heater Bypass Kit Recommendation

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching