Can Dexter 10 Hub and Rotor # K08-435-05 be Used on EZ Lube Spindles
Updated 03/21/2018 | Published 03/19/2018
Products Featured in This Question
Question:
are these for a ez lube system. i have a 1987 ranger trail trailer and i need the hubs replaced. it has a zerk fitting on the end of the spindle. thanks
asked by: Parker S
0
Expert Reply:
The Titan 10" Hub and Rotor # K08-435-05 that you referenced can be used with EZ lube spindles. In order to do that you'd need to use the correct grease caps and you'd be set. For that all you need is the part # RG04-040 which has the removable center sections to make it EZ lube spindle compatible.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter 10" Hub-and-Rotor Assembly - 5 on 4-1/2 - Zinc - 3,500 lbs
- Trailer Hubs and Drums
- Hub with Rotor
- Standard
- L68149 / L44649
- Marine Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Replacement Hub/Rotor for UFP 41030
- Q&A: Replacement Disc Brakes for 2018 Load Rite Boat Trailer With TDE 660
- Q&A: Replacement Disc Brake Rotor/Hub For a 1990 Ranger Trail Boat Trailer
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Q&A: What Inner and Outer Bearings Does 3,500 lb Axle Disc Brake Kit Use
- Q&A: Recommended Replacement Hubs for EZ Loader Trailer With Disc Brakes
- Q&A: Replacing Older Tie Down Engineering 46210 and 46845 Trailer Hubs
- Q&A: Will Aluminum Hi-Spec Series 04 Star Mag Trailer Wheel # AM20258 Work with ST175/80R13
- Article: Trailer Wiring Diagrams
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Most Popular Wheel Bearings
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern