Install Time for the Torflex Lift Kit # K71-707-02

Question

Question:

what is the average amount of time for installation for a dexter lift kit? tandem axle

asked by: Mike G

0

Expert Reply:

If you are comfortable working with tools then the install of the Torflex Lift Kit # K71-707-02 will take you about a day. There is a great customer review that says it took him 6 hours to complete the installation at home.

If you will be taking it to a shop then it really just depends on how good the shop is. You may need to just call around and see what they say.

A review video and the installation instructions have been linked for you to check out.

expert reply by: Jon G

0

Answer 1

I can definitely help and point you in the right direction. We have a few lift kits available and it will just depend on exactly what kind of axles you have on your camper. The Lift kit #K71-725-02 that you were looking at will #12 Torflex axles with…

view full answer...

Answer 2

It's ok if you have 2,200 lb axles; so long as you have a #10 Dexter Torflex Axle the correct lift kit is the following: - Torflex Lift Kit - Tandem Axle #K71-707-02

view full answer...

Answer 3

Although we do not offer that exact replacement fan motor for the Everchill Refrigerators you can use Valterra FridgeCool Automatic Exhaust Fan Item #A10-2618VP which is a universal fit motor and will work with any refrigerator.

view full answer...

Answer 4

I'll start off by saying that typically the flashing green lights on your MaxxFan #MA00-04000K means that there is some sort of voltage issue and even though when you tested you're getting what seems to be proper voltage, I would guess there…

view full answer...

Answer 5

Dexter Nev-R-Lube Bearings such as the 50MM #31-71-3 referenced in your question do not have a specific maintenance or replacement schedule. These are pre-lubricated at the factory, which will make it resistant to contamination, and sealed for life…

view full answer...

Answer 6

The Dexter Torflex Lift Kit #K71-707-02 referenced in your question is designed for the #10 Torflex axle with a 2,300 to 4,000 pound capacity. As you mentioned, the lift kit cannot be used with Torflex axles that use a 3 inch high profile bracket.…

view full answer...

Answer 7

The Torflex Lift Kits like part #K71-707-02 do come with a protective painted black finish. As mentioned, the paint can chip if not careful. That said, the finish is not really crucial for most applications which is why the paint is not as durable.…

view full answer...

Answer 8

Your axle is a 3,500 pound axle so the lift kit you need is #K71-707-02. This is for axles rated between 2,300 to 4,000 pounds. It'll give you a lift of 2-5/8 inches. The #K71-725-02 kit is for 5,500 to 7,000 pound axles.

view full answer...

Answer 9

Hi Roger; are you referring to the 3-1/8" lift on the Torflex Lift Kit #K71-725-02? All of the lift kit heights are set by Dexter and are specific to your Torflex axle model so you really don't have a choice. The 3-1/8" is only designed…

view full answer...

Answer 10

Thanks for the pictures of your axles, based on that you do not have the 3 inch high profile bracket so the lift kit part #K71-707-02 would fit. The taller profile bracket is essentially like a taller bracket above the axle that sits up higher almost…

view full answer...