Brake Controller Install Video for 2014 Toyota Tacoma that Shows Harness Connections

Question

Question:

I have a 2014 toyota tacoma access cab with tow package pre wired. I found the plug, up behind the parking break. But how do you plug in the special cable i got extra. Theirs no slack in the plug i can hardly reach it. How do i get it pluged in?? Thanks

asked by: Darrell G

0

Expert Reply:

I attached an install video below that shows the install harness part # 3040-P used to install a Prodigy P2 part # 90885 in a 2012 Toyota Tacoma that will be the exact process as your 2014 model.

In the video we installed the controller on the left side of the steering wheel to help not need a lot of extra slack. Let me know if you need more help!

expert reply by: Jameson C

0

Answer 1

Hey Ray. The Active Controls ActiveStart Plug-In Soft Start for RVs item #AS44FR is designed and assembled in Pompano Beach, Florida. The individual components are sourced from all over. It ships from our warehouse in Wentzville, Missouri and has a…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 10

Sure, I can help with that. I can see why the fitment notes are confusing. For a 2012 Toyota Tundra with the factory tow package and factory 7 way connector, you'll want a brake controller that plugs into the factory brake controller port under…

view full answer...

Answer 11

Hey Fernando, I'd be happy to help you pick out the correct Timbren rear suspension kit for your 2023 Toyota Tacoma TRD that will be towing a trailer. Really it comes down to two options. You would want the part #TTORTUN4L for if you have the 3…

view full answer...

Answer 12

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Brake Controller Install Video for 2014 Toyota Tacoma that Shows Harness Connections

Featured Help Information

Miscellaneous Media

Continue Researching