Will the Redline Flush Mounted Door Latch L1833 Open from the Inside When Locked

Question

Question:

Can this latch be opened using the inside release knob when the lock is locked? Or does the lock prevent opening from the inside as well?

asked by: Jeff S

0

Expert Reply:

I ran out to the warehouse, and pulled one of the door latches, part # L1833 off the shelf. I can confirm that the latch will indeed open using the inside knob when the latch is in the locked position.

expert reply by: Mike L

0

Answer 1

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 2

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 3

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 4

Typically, the Junior Door Latch would install by routing or cutting out a 2-3/4 by 3-3/4 inch hole and would then either be bolted or riveted to the door through holes that would need to be drilled in the flange around the latch. The latch is meant…

view full answer...

Answer 5

Hi Tracy, thanks for reaching out. If the measurements you provided (about 5-1/4" tall by 5-5/8" wide) are the cutout size, the closest option we have is the Bauer Products Motorhome Door Lock #BA64FR. That lock is designed for a…

view full answer...

Answer 6

The Locking Stainless Steel Flush Door Latch, Part #L1833 does not come with a gasket or a striker plate. This is a flush mount latch and will fit in doors up to 7/8 inches thick. I have attached a photo of the latch with the dimensions. I have also…

view full answer...

Answer 7

It would appear that your CM Dakota horse trailer uses a door latch like the Locking Steel Flush Door Latch with Inside Release #L1930. I have included an image with the measurements for this latch. Please let me know if your latch is different than…

view full answer...

Answer 8

Hey Tom. The P&F Products Nosing Edge Trim for Enclosed Trailers item #PF28FR measures 93-1/2" long. What kind of trailer do you have?

view full answer...

Answer 9

Hey Tim! Most trailers have the standard A-frame bolt pattern for jack mounting. More than likely your trailer is no different. The Trailer Valet Electric Tongue Jack with Digital Tongue Weight Scale #TV95FR is designed to fit the standard as well as…

view full answer...

Answer 10

Hey Dylan - both M-3 plates measure 81-3/4 inches wide, so you'd need to trim off a little bit. The aluminum one #M348FR would be easier to trim, so I'd pick that over the steel one. The hinge runs the full width so you’ll still get solid…

view full answer...

Will the Redline Flush Mounted Door Latch L1833 Open from the Inside When Locked

Product Page this Question was Asked From

Continue Researching