Full Replacement Towing Mirrors for a 2014 Toyota Tundra

Question

Question:

HOW CAN I TELL IF MY 2014 TOYOTA TUNDRA WILL ACCOMADATE THE NEW TOWING MIRRORS WITH TURN SIGNALS AND HEATED MIRRORS/ MY ORIGNAL EQUIPMENT ONLY HAS HEATED MIRRORS!

asked by: Troy

0

Expert Reply:

All of the full replacement towing mirror options we have for your 2014 Toyota Tundra like the K-Source Custom Extendable Towing Mirrors w/ Turn Signals part # KS70103-04T for black or part # KS70131-32T for chrome will retain the functions of your existing mirrors but will not give you any new features.

For example, even though the above towing mirrors have heated, electric, and lighting functions, your OEM mirrors only have heated and electric functions therefore these would be the only two features the new mirrors will have. The new mirrors will have the wires for the turn signals in the mirror but the wiring harness on the vehicle is not present.

I have attached a photo of each mirror installed on similar Toyota Tundra's for you as well.

expert reply by: Conner L

0

click to enlarge

Answer 1

Hey Don! For a replacement you can use the Trailer Idler Hub Assembly for 4,200-lb Axles #DX45BR. This has a 5 on 4-1/2 bolt pattern with #L68149 inner and outer bearings. It also has a galvanized finish which will be perfect for your boat trailer.…

view full answer...

Answer 2

I was able to find the 126003 hub and was able to determine that it is a 3,500 lb hub/drum with a 5 on 4-1/2 inch bolt pattern just like the #AKHD-545-35-K that you referenced. This hub will work as a replacement for your Lippert.

view full answer...

Answer 3

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 6

Hi Bill, The MORryde AllTrek 4000 Equalizer part #MR29DR is not intended to raise the height of your camper, it would offer little to no lift. The 4" of suspension travel listed on the product page is in reference to how much the suspension can…

view full answer...

Answer 7

Hi Jordan! The Dexter Bearing Kit for 1-1/16" to 1-3/8" Tapered Spindle #DX76ER uses bearings and seals that are made overseas. They aren't really "branded", per se, but Dexter does have them made specifically for them. If you…

view full answer...

Answer 8

Hey Bobby, we have the Firestone Ride Rite kit part #F33VV that is a confirmed fit for your 2024 GMC Canyon AT4. Whenever available I recommend the Firestone kits as they have the highest quality bags. Are you wanting a compressor kit too?

view full answer...

Answer 9

Hello Ken, thanks for reaching out. The CIPA Custom Towing Mirror #10801 would not be a fit for a 2022 Honda Ridgeline. This mirror fits the following vehicles: 2002 - 2006 Chevrolet Avalanche 2000 - 2006 Cadillac Escalade 2002 - 2006 Cadillac…

view full answer...

Answer 10

Hello Cary, thanks for reaching out. The mirrors on your transit are definitely oversized, but we do have a towing mirror option for this. Here is what I recommend: - CIPA Universal Towing Mirrors - Clamp On - Qty 2 #CM11980-2 With the mirrors being…

view full answer...

Answer 11

Both the K-Source towing mirrors, #KS81300, and the CIPA towing mirrors, #CM11300, do fit if your 2012 Toyota Tundra has electric and/or heated stock side mirrors. They will not fit Limited or Platinum models though. I agree that the K-Source mirrors…

view full answer...

Answer 12

Hey Marion, the Curt True Course part #C94VV and the sway control system built into the new GM truck essentially do the same thing so you really wouldn't need to run both at the same time. The two will work independently of each other and…

view full answer...

Full Replacement Towing Mirrors for a 2014 Toyota Tundra

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching