Recommended Lippert Quad Step to Match Part Number 358991 on Grand Design 351M
Updated 12/04/2017 | Published 12/02/2017 >
Products Featured in This Question
Question:
I am looking for a quad Lippert step that matches this part number 358991. I want to replace the solid stairs with the ones already mounted aft in the Grand Design 351M. I found the above number on the aft step we want to match. I believe they should bolt right in with minor trim work fabrication. Please advise.
asked by: John B
Expert Reply:
The quad steps you are looking for are the Lippert Alumi-Tread Manual Pull-Out Step for RVs # LC432698. These steps are 24 inches wide and have an 8-1/2 inch rise. From the top of the mounting bracket to the bottom of the step you will have a total run of 49-5/8 inches. The mounting holes are 7 inches on center deep and 26-3/4 inches wide. The outer mounting dimensions are 9-1/2 inches by 28 inches.
If the mounting holes do not line up, you can use the Lippert Outriggers for Manual RV Steps # LC301704 to give you different mounting hole locations with proper support.
Product Page this Question was Asked From
Alumi-Tread Manual Pull-Out Step for RVs - 8" Drop/Rise - 24" Wide - Quad - Aluminum
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 28 Inch Wide
- 4 Steps
- 8 Inch Drop/Rise
- Aluminum
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Alumi-Tread Manual Pull-Out Step for RVs - 8" Drop/Rise - 24" Wide - Quad - Aluminum
- Search Results: 4 steps rv steps
- Search Results: folding steps
- Article: Trailer Wiring Diagrams
- Search Results: trailer tires and wheels
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Video: Furrion Chill Cube RV Air Conditioner Review and Installation - Travel Trailer Edition
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Trailer Hitch
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Search Results: trailer hitch
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Shop: Trailer Wiring
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Shop: Suspension Enhancement
- Q&A: How Is Replacement 22-1/2" Right Rear Leg for Lippert Ground Control 3.0 Measured
- Video: The Low-Down on the Alumi-Tread Manual Pull-Out Step for RVs
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: trailer wiring
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Q&A: Can I Get MORryde Suspension Upgrade Kit MR86ZR With Two Extra Sets Of Shackle Straps?
- Search Results: trailer leaf springs
- Shop: Gooseneck Hitch
- Search Results: trailer hubs and drums
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Shop: Brake Controller
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord


